Now comes complete with free "built in" pressure gauge!The RO unit includes:
1 x comprehensive instruction manual
3 x 150 US gallon per day membrane
1 x 5 micron Sediment Pre-filter
1 x Granular Activated Carbon Pre-filter
1 x Carbon Block Pre-filter
1 x Pressure Gauge
1 x Feed Water Clamp
1 x Waste Water Clamp
1 x Filter Housing Wrench
2 Metres of Red Tubing
2 Metres of Green Tubing
2 Metres of Blue Tubing
1 x Membrane Flush Kit
Please click here for Replacement Filter Kits Installation Guide PDF
A full size 6 stage ro unit producing 450 Gallons of water per day (approximately 70 litres per hour depending on system parameters below), removing upto 99% of tap water contaminants. Please note
this is the only 6 Stage unit that does not have DI Post Filtration, the system is designed to potentially reduce your waste water to a 1:1 ratio with it's triple membrane set up. Great for customers on a water meter wanting to produce large quantities of pure water but reduce the waste water.
The 6 stage ro unit has the benefits of the 3 & 4 stage including the superior large 10inch pre-filters and includes a membrane flush system which reduces fouling to extend membrane life. (This unit is the only 6 Stage that does not have DI Post Filtration.)
Be aware if your pressure is low you will likely require a booster pump for this triple membrane system to work as required.
Ideal for aquariums, window cleaning, car washing and can also be used for drinking water when used with our pressure tank kit.
The effectiveness and productivity of RO systems increase with greater water pressure and temperature. The actual flow rate (in GPD) of any reverse osmosis system depends on your home water pressure and temperature.
Manufacturers recommend 60 psi is required at the membrane for full production, not everyone's cold water is at 60 psi and 77 degrees F; therefore, you might get less than 450 GPD, perhaps 50% or even less if your pressure and temperature are very low! Please consider these factors before you finally decide on which system is best for you.
Pre-filters should be replaced every 6 months or 2500gallons (or when visibly dirty). If any of your pre filters are exhausted, using the unit will put additional pressure on the membrane. Filters are much cheaper to replace than a damaged membrane, which are also available on the website.
All RO-World Reverse Osmosis Systems are shipped fully assembled and we provide email support.People who bought this item also bought:
Self Regulated Booster Pump 36GPD to 150GPD
Auto Shut Off Kit With Float Valve